High Quality 18mm Stainless Steel Wideband O2 Bung. Zeitronix ZT-3 Wideband O2 Installation Guide
Z125 ECU FLASH SOFTWARE
Purchase this item to gain access in the Woolich Racing Tuned software to the stock bin files for the 2016-2018 Kawasaki ZX10Rįeatures available for Kawasaki ZX10R 2016-2018 This harness allows you to connect the 2 pin plug used on our Bench Harnesses to a 12v Power Supply with a standard 2.5mm barrel connector.īin File Definitions - for use in Woolich Racing Tuned softwareĢ016-2018 ZX10R Stock Bin File Definitions The Extension Harness - Long is a 8 pin Molex (male) to 8 Pin Molex (female) extension harness 600mm long that allows you to extend the length of all Woolich Racing Harnesses.īarrel to 2 Pin Plug Bench Harness Power Supply Connector The Extension Harness - Long is a 8 pin Molex (male) to 8 Pin Molex (female) entension harness 1100mm long that allows you to extend the length of all Woolich Racing Harnesses. The Kawasaki Pit Speed Limiter harness plugs into the bike's Exhaust Valve Plug and allows the rider to enable the Pit Speed Limiter and, where available, the Engine Warm Up feature. Kawasaki Pit Speed Limiter Harness Type 1 This product includes the Kawasaki Pit Speed Limiter Harness Type 1 and Pit Speed Limiter Key allowing you to enable the Pit Speed Limiter in 1 ECU within the Woolich Racing Tuned (WRT) software. If you have purchased the Race Tools package you do not need to purchase this key.Ģ016-2018 Kawasaki ZX10R Pit Speed Limiter Launch Control is part of the Race Tools package. Purchase this item to allow you to enable the Woolich Racing Launch Control. ** The Pit Speed Limiter and Engine Warm Up, requires the purchase of an additional Pit Speed Limiter Harness.Ģ016-2020 Kawasaki ZX10R Launch Control Key
** This harness uses the stock exhaust valve plugs on the bike's harness, the stock exhaust valve should be removed from the bike and disabled in the WRT software This item is for the Race Tools Key Only, it allows you to enable Woolich Racing Race Tools using the stock Shift Sensor.
Z125 ECU FLASH INSTALL
If you do not have a Woolich Racing Interface you can also visit a Woolich Racing - Tuning Partner and have them install and configure the Race Tools (additional fees and charges will apply). You can purchase this as a package on the product page for your bike.
You will need to use the relevant Woolich Racing Interface and Bin File Definition to enable and configure Race Tools and write to the ECU. Woolich Racing Race Tools requires you to Write the ECU. ** The Pit Speed Limiter and Engine Warm Up requires the purchase of an additional Pit Speed Limiter Harness. * Contact us after ordering if you have after-market rearsets or are using a race shift pattern and we will swap the shift rod for a generic rod that can be cut and tapped to the correct length. Launch Control allows you to configure Delay, Launch RPM and Hold Speed.Įngine Warm up parameters are fully configurable. Pit Speed Limiter RPM can be configured.**
Z125 ECU FLASH FULL
Quickshifter Kill times are configurable per gear with 3D maps allowing Kill Times to be set for the full range of TPS and RPM combinations.Īutoblipper Opening and Target maps are fully configurable per gear.
Race Tools: Quickshifter, Launch Control, Pit Speed Limiter
0 kommentar(er)
